|
REFILLING YOUR JUDKINS TRIO TAPE
DISPENSER
There are directions on the inside of
the box that came with your dispenser, but they aren't
very useful. It's very easy to get lost trying to figure
out which reel goes where and which way it should go
on so here some clear pictures and instructions!
 Take
the clear lid off the base by pulling straight up.- Pull out the components 1 by 1 until
you get to the roll that needs to be replaced. (The
1/2" is on top and easiest to refill . It aksi
costs the same to refill as the 1/4" and 1/8"
rolls so I use that one the most.)
- Replace the components. When replacing
the compenents these hints will make putting the tape
back in correctly:
- Make sure that each time you put
in a roll, you give yourself some lead tape and that
lead tape has the adhesive side facing toward the
ridged guide on the inside of the bottom of the case
(the 1/2" only has a ridged guide on the inside
of the cover, but if you make sure that roll is going
the same direction as the other two, you'll be fine.
- The 1/8" tape goes through the
guide on the base that is niether the tallest, nor
the shortest. The 1/4" tape goes through the
tallest guide on the base and 1/2" tape doesn't
get much of a guide on the base because it's guide
is on the clear top.
 Put
the compenents back in in this order from bottom to
top:
- 1/8" tape roll
- larger red separator as shown, with
flatter side down
- 1/4" tape roll
- small red sparator with flat side
down (I actuall fit this into the 1/2" tape roll
as shown and replace the two together. You just have
to make sure the tape is rolling off in the same direction
shown)
- 1/2" tape roll
*important note: there is a notch in
each of the red separators. After you put the top red
separator in durn it until you feel it click in, otherwise
the clear cover won't fit back on correctly.
- Replace the cover. the tip marked
12mm matches up with the half inch lead tape. Take
care that each roll of tape is fitting through the
holes before pushing cover down.
|
